FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
176 CLI Reference Guide for Directors and Edge Switches
Output
The output from perf.preferredPath.showPath includes the following parameters:
Command and Output Examples
The following examples show the output returned by the three methods of
specifying the perf.preferredPath.showPath command.
Single values for both parameters
Root> perf preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port: Not Configured
destDomainId set to all
Root> perf preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain Preferred Exit Port
------------------ -------------------
1 23
3 24
4 23
17 12
sourcePort set to all
Root> perf preferredPath showPath 1 all
Preferred Path State: Enabled
Source Port Preferred Exit Port
------------------ -------------------
0 2
Destination
Domain
The destination domain ID for which a
preferred path has been configured. This is
displayed only if the destination domain
parameter is set to all.
Source Port This is the source port for which a preferred
path to the specified destination domain ID is
specified. This is displayed only if the source
port parameter is set to all.
Preferred Exit
Port
The configured Preferred Path exit port. This
value can be any port number, or blank to
indicate that no Preferred Path has been
configured.