FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)
CLI Commands
178 CLI Reference Guide for Directors and Edge Switches
perf.thresholdAlerts Commands
The perf.thresholdAlerts commands enable you to configure alerts that notify you
of specific conditions on your system.
You can configure a maximum of 16 threshold alerts, including both counter
threshold alerts (CTAs) and throughput threshold alerts (TTAs). Each of these
types of alerts have commands that are specific to the alert type.
■ Counter threshold alerts: These are alerts that are triggered by counts of
events. The commands used to configure these alerts start with
perf.thresholdAlerts.counter.
■ Throughput threshold alerts: These alerts are triggered by port throughput.
The commands used to configure these alerts start with
perf.thresholdAlerts.throughput.
These commands include the following:
■ perf.thresholdAlerts.counter.addAlert, page 183
■ perf.thresholdAlerts.counter.addPort, page 184
■ perf.thresholdAlerts.counter.removePort, page 186
■ perf.thresholdAlerts.counter.setCounter, page 187
■ perf.thresholdAlerts.counter.setParams, page 188
■ perf.thresholdAlerts.counter.show, page 190
■ perf.threshAlerts.counter.showStatisticTable, page 191
■ perf.thresholdAlerts.deleteAlert, page 192
■ perf.thresholdAlerts.setState, page 193
■ perf.thresholdAlerts.throughput.addAlert, page 194
■ perf.thresholdAlerts.throughput.addPort, page 196
■ perf.thresholdAlerts.throughput.removePort, page 198
■ perf.thresholdAlerts.throughput.setUtilType, page 199
■ perf.thresholdAlerts.throughput.SetUtilPercentage, page 200
■ perf.thresholdAlerts.throughput.setParams, page 201
■ perf.thresholdAlerts.throughput.show, page 203
■ perf.thresholdAlerts.throughput.showUtilTypeTable, page 204
For a list of the available threshold alerts counters, see “Alert Types and
Counters” on page 180.