FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

perf.thresholdAlerts.counter.setCounter
187CLI Reference Guide for Directors and Edge Switches
Syntax
setCounter name counterNumber
Purpose
This command sets the counter statistic that will be used to trigger the counter
threshold alert. Use this command to associate a counter with the threshold alert
name created using the command “perf.thresholdAlerts.counter.addAlert” on
page 183.
Note: An alert cannot be modified unless it is in the disabled state. Verify that the
alert is disabled before executing this command.
Parameters
This command has the following parameters:
Command Example
Root> perf thresholdAlerts counter setCounter checklinks 1
perf.thresholdAlerts.counter.setCounter
name The name of a counter threshold alert as
defined by the command
“perf.thresholdAlerts.counter.addAlert” on
page 183.
counterNumber Specifies the counter number. Valid values
are shown in Table 5.