FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
194 CLI Reference Guide for Directors and Edge Switches
Syntax
addAlert name
Purpose
This command configures a new throughput threshold alert and assigns it a name.
The new alert is assigned default settings that can then be changed using the other
throughput threshold alert commands.
The default settings for a new counter threshold alert are as follows:
■ Ports: None
■ Utilization Type: None
■ Utilization Percentage: 50%
■ Duration: 30 minutes
■ Interval: 60 minutes
■ Alert State: Disabled
Parameters
This command has the following parameter.
Note: Although the system supports a name length of 64 characters, you may want to
use a much shorter name. Some commands that display the threshold name show a
maximum of 51 characters. If you specify lengthy names, you can display the
complete name by entering the comma-delimited mode using the commaDelim
command.
perf.thresholdAlerts.throughput.addAlert
name Specifies the name of the new throughput
threshold alert. This name can consist of any
ASCII characters up to a maximum length of
64 characters. To use spaces or special
characters in this name, put quotation marks
around the name. This parameter is
case-sensitive.