FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

perf.thresholdAlerts.throughput.setUtilType
199CLI Reference Guide for Directors and Edge Switches
Syntax
setUtilType name utilizationType
Purpose
This command sets the throughput statistic that is used to trigger the throughput
threshold alert.
Note: An alert cannot be modified unless it is in the disabled state. Verify that the
alert is disabled before executing this command.
Parameters
This command has the following parameters:
Command Example
Root> perf thresholdAlerts throughput setUtilType eportRx 1
perf.thresholdAlerts.throughput.setUtilType
name The name of a throughput threshold alert as
defined by the command
“perf.thresholdAlerts.throughput.addAlert” on
page 194.
utilizationType The type of traffic that triggers the alert. Enter
the number that corresponds to the desired
utilization type:
1 - Transmit Traffic (Tx)
2 - Receive Traffic (Rx)
3 - Both (Rx and Tx)