FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
200 CLI Reference Guide for Directors and Edge Switches
Syntax
SetUtilPercentage name utilizationPercentage
Purpose
This command sets the throughput utilization percentage that is used to trigger the
throughput threshold alert.
Note: An alert cannot be modified unless it is in the disabled state. Verify that the
alert is disabled before executing this command.
Parameters
This command has the following parameters:
Command Example
Root> perf thresholdAlerts throughput SetUtilPercentage eportRx
70
perf.thresholdAlerts.throughput.SetUtilPercentage
name The name of a throughput threshold alert as
defined by the command
“perf.thresholdAlerts.throughput.addAlert”
on page 194.
utilizationPercentage The percentage of throughput utilization
that triggers the alert. This must be entered
as a number. Accepted values are in the
range 1 to 100.