FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

perf.thresholdAlerts.throughput.setParams
201CLI Reference Guide for Directors and Edge Switches
Syntax
setParams name duration interval
Purpose
This command sets the duration and interval times for a specified throughput
threshold alert. This command enables you to configure the alert to be sent if both
of the following events occur:
■ The throughput threshold alert value is surpassed for more than the timespan
specified for the duration parameter.
■ The duration parameter is surpassed within the time frame specified by the
interval parameter.
Parameters
This command has the following parameters:
perf.thresholdAlerts.throughput.setParams
name The name of a throughput threshold alert as
defined by the command
“perf.thresholdAlerts.throughput.addAlert” on
page 194.
duration The duration time, in minutes, that the
utilization must exist to trigger the alert.
Acceptable values are in the range 0 to
70,560 minutes. Setting this value to zero
means that the alert is triggered if the specified
utilization is exceeded at any time. The value
of this parameter must be equal to or greater
than the value of the interval parameter.
interval This sets the interval time in minutes. The
interval is a fixed length of time. It is not a
rolling window of time. Acceptable values are
in the range 0 to 70,560 minutes. The value
of this parameter must be greater than or equal
to the value of the duration parameter.