FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

perf.thresholdAlerts.throughput.show
203CLI Reference Guide for Directors and Edge Switches
Syntax
show name
Purpose
This command displays the settings for an individual throughput threshold alert.
Parameters
This command has the following parameter.
Note: The output of this command truncates threshold alert names that are longer
than 51 characters. If you specify lengthy names, you can display the complete name
by entering the comma-delimited mode using the commaDelim command.
Command Example
Root> perf thresholdAlerts throughput show eportRx
Output Example
The output from the perf.thresholdAlerts.throughput.show command displays as
follows.
Name: 90% Receive Throughput Threshold
Ports: 5,8,12,20-24
Utilization Type: Rx
Utilization Percentage: 90%
Duration: 15
Interval: 30
Alert State: Disabled
perf.thresholdAlerts.throughput.show
name The name of a throughput threshold alert as
defined by the command
“perf.thresholdAlerts.throughput.addAlert” on
page 194.
You can specify all instead of a name, which
means that all threshold alerts are displayed.