FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
234 CLI Reference Guide for Directors and Edge Switches
Syntax
exit destDomainID sourcePort
Purpose
This command displays the exit port from a source port to a given destination
domain. This command shows the Preferred Path configuration.
Use all for one of the command’s parameters to display all configured and
actual exit ports for either the destination domain ID or the specified source Port.
You cannot specify all for both parameters. If the destination domain is set to
all, then all paths from the specified source port are displayed. If the source port
is set to all, the output shows all source port paths to the specified domain.
Parameters
This command has the following parameters:
show.port.exit
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31, or, use all
to show all exit ports to and from the source port
specified in the sourcePort parameter.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0-23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140
Or, you can specify all to show all exit ports
to the destination domain ID specified for the
destDomainId parameter.