FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
242 CLI Reference Guide for Directors and Edge Switches
Type The operational port type.
If the configured port type is F_Port or E_Port, this
value will match the configured type.
If the configured type is G_Port, this value can be
E_Port, F_Port, or G_Port, depending on what is
connected to the port.
On the Edge Switch 2/24, if the configured port type
is Fx_Port, the operational port type can include
FL_Port in addition to the values noted above for
F_Port. If the configured port type is Gx_Port, then
the operational port type can include FL_Port in
addition to the values noted above for G_Port.
Attached WWN The World Wide Name of the device or switch
attached to the port, if one is attached.
Beaconing The beaconing state for the port (true or false).
Reason An optional message number that indicates if the port
has a segmented ISL or if a port binding violation has
occurred, or if the part is inactive.
The message description for this message number is
provided at the bottom of the table.
If the operational state is Segmented E_Port,
only the following messages can be generated:
■ 01 Segment Not Defined
■ 02 Incompatible Operating Parameters
■ 03 Duplicate Domain ID(s)
■ 04 Incompatible Zoning Configurations
■ 05 Build Fabric Protocol Error
■ 06 No Principal Switch
■ 07 No Response from Attached Switch
■ 08 ELP Retransmission Failure Timeout