FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
248 CLI Reference Guide for Directors and Edge Switches
Output
The output from show.preferredPath.showPath includes the following parameters:
Command and Output Examples
The following examples show the output returned by the three methods of
specifying the show.preferredPath.showPath command.
Single values for both parameters
Root> show preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port: Not Configured
Actual Exit Port: 45
destDomainId set to all
Root> show preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain Preferred Exit Port Actual Exit Port
------------------ ------------------- ----------------
1 23 23
3 24 No Path
4 23 23
17 12 No Source
Destination
Domain
The destination domain ID to which a preferred
path has been configured. This is displayed only
if the destination domain parameter is set to
all.
Source Port The source port for which a preferred path to the
specified destination domain ID is specified.
This is displayed only if the source port
parameter is set to all.
Preferred Exit
Port
The configured Preferred Path exit port. This
value can be any port number, or blank to
indicate that no Preferred Path has been
configured.
Actual Exit Port This is the actual exit port being used for the
given path.