FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Introduction
26 CLI Reference Guide for Directors and Edge Switches
Note that the order in which commands are entered determines the order in which
the show commands display the values. Refer to “CLI Commands” on page 39
for examples of show commands output.
Navigation of the CLI Command Tree
Once the administrator or operator logs in and receives the Root> prompt, the
CLI commands are accessed by navigating up and down the CLI command tree.
To move from the root through the any of the four extended branches, enter the
name of the next branch as shown in Table 3. For example, to use the
config.port.name command to configure the name for port 4 on the edge
switch, this series of commands is entered:
Root> config
Config> port
Config.Port> name 4 “HP Tape Drive”
At this point, to enter the maint.port.beacon command to set the beaconing
state of port 4, the following series of commands is entered:
Config.Port> ..
Config> ..
Root> maint
Maint> port
Maint.Port> beacon 4 true
Note: You must return all the way to the root of the tree to transition to another
extended branch. When traversing back to the root, the name of each branch cannot
be used. Instead use the double-dot command (two periods) to move back towards the
root. Only one double-dot command may be entered at a time.