FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
272 CLI Reference Guide for Directors and Edge Switches
Error 29: Invalid
Gateway Address
The value entered for the
gateway address is
invalid.
The new gateway
address for the Ethernet
interface must be entered
in dotted decimal format
(for example, 0.0.0.0).
Enter the gateway
address for the Ethernet
interface in the dotted
decimal format.
Error 30: Invalid IP
Address
The value entered for the
IP address of the director
or edge switch is invalid.
The IP address for the
Ethernet interface must be
entered in dotted decimal
format (for example,
10.0.0.0). Enter the IP
address for the Ethernet
interface in dotted
decimal format.
Error 31: Invalid Subnet
Mask
The value entered for the
new subnet mask for the
Ethernet interface is
invalid.
The subnet mask must be
entered in dotted decimal
format (for example,
255.0.0.0). Enter the
subnet mask for the
Ethernet interface in
dotted decimal format.
Error 32: Invalid SNMP
Community Name
The value entered for the
SNMP community name
is invalid.
The SNMP community
name is the name of the
community specified in
the command
“config.snmp.addCommu
nity” on page 94. The
community name must
not exceed 32
characters. Valid
characters include all
those in the ISO Latin-1
character set. Duplicate
community names are
allowed, but the
corresponding
writeAuthorization values
must match. Enter an
SNMP community name
that meets all of the
requirements.
Table 6: CLI Error Messages (Continued)
Message Description Action