FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
278 CLI Reference Guide for Directors and Edge Switches
Error 82: Invalid Interop
Mode
The value entered for the
interoperability mode is
not valid.
The interoperability mode
for the director or edge
switch must be
Homogenous Fabric or
Open Fabric 1.0. Enter
mcdata (Homogenous
Fabric) or open (Open
Fabric 1.0) to set the
interoperability mode.
Error 83: Not Allowed in
Open Fabric Mode
This request cannot be
completed while this
switch is operating in
Open Fabric 1.0 mode.
Configure the
interoperability mode to
Open Fabric 1.0 mode.
Error 88: Invalid Feature
Key Length
The value of the specified
feature key is longer than
the maximum length
allowed.
Refer to the command
“config.features.installKe
y” on page 45for
requirements, and reenter
the feature key. If
problems persist, contact
your sales representative.
Error 89: Not Allowed in
S/390 Mode Without the
SANtegrity™ Feature -
This procedure is not
allowed in S/390 mode
(FICON management
style in HAFM).
The entered command is
only supported when the
product is in Open
Systems mode (Open
Systems management
style in HAFM). The
product cannot be taken
out of S/390 mode
(FICON management
style) through the CLI. Use
the HAFM application to
change the product
management style, and
then reenter the
command.
Error 90: Invalid Port
Type
The configured port type
is invalid.
The port may be
configured as an E_Port,
G_Port, or F_Port.
Reconfigure the port, and
then resubmit the
command.
Table 6: CLI Error Messages (Continued)
Message Description Action