FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
286 CLI Reference Guide for Directors and Edge Switches
Error 157: Access
Control List is Disabled
The switch must be offline
and Fabric Binding must
be inactive before this
feature can be disabled.
Deactivating this feature
can be disruptive to
Fabric operations. Take
the switch offline and
deactivate fabric binding
before disabling this
feature.
Error 158: Invalid IP
Access Control List Pair
The pair of IP addresses
are invalid and cannot be
added to the list.
Make sure the IP
addresses are valid and
the first IP is lower than
the second.
Error 159: Invalid IP
Access Control List Pairs
Count Value
The list being activated
has an invalid number of
IP pairs.
Make sure there is at least
one IP address in the
Access Control List.
Error 160: Management
Client IP Not Included In
IP Access Control List
The management
interface IP address is not
in the list.
The management IP must
be in the list or the current
connection would be lost.
Error 161: SANtegrity
Authentication feature
key must be uninstalled
The operation cannot be
completed with the
SANtegrity
Authentication key
installed.
Remove the SANtegrity
Authentication feature
key.
Error 162: List is full There is no more room
for new entries in the list.
Remove a different entry
and try again.
Error 163: FICON MS
feature key must be
installed
The command is not
available without the
FICON MS feature key.
Install the FICON MS
feature key.
Error 164: FICON CUP
Zoning feature key must
be uninstalled
The operation cannot be
completed with the
FICON CUP Zoning key
installed.
Remove the FICON CUP
Zoning feature key.
Error 165: CUP Zoning
feature key must be
installed
The command is not
available without the
FICON CUP Zoning
feature key.
Install the FICON CUP
zoning feature key.
Error 166: CUP Zoning
feature must be enabled
The command cannot be
completed with the CUP
Zoning feature enabled.
Enable FICON CUP
Zoning.
Table 6: CLI Error Messages (Continued)
Message Description Action