FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)
Error Messages
287CLI Reference Guide for Directors and Edge Switches
Error 167: Diagnostics
can not be run on
inactive port
The port is in the inactive
state and diagnostics
can't be run.
The port state must
change out of the inactive
state.
Error 168: Duplicate
member in the list
The port is in the inactive
state and diagnostics
can't be run.
The port state must
change out of the inactive
state.
Error 169: CNT support
in is an incorrect enabled
state
CNT support is in the
wrong state.
The enabled state for
CNT support must be
changed.
Error 170: Duplicate IP
Address pair in the
Access Control List
uplicate IP address pairs
are not allowed in the
Access Control List.
This command is
redundant, the member
already exists in the list.
Error 171: Invalid
username
The username is invalid. Enter a unique username
using only the allowed
characters and proper
length.
Error 172: Invalid list size The number of entries in
the list is invalid.
Make sure the list has at
least one entry.
Error 173: Invalid value The value being entered
is invalid.
Enter a valid value.
Error 174: Invalid list
data
The list data is invalid. Correct the list to make it
a valid list.
Error 175: Invalid list
index (the user should not
see this error)
The index in the list is
incorrect.
Correct the index.
Error 176: Entry not
found in the list
The desired entry in the
list does not exist.
Make sure the desired
entry is in the list and it is
being typed correctly.
Error 177: Cannot
remove the last user with
Administrator rights
At least one
Administrator user must
exist for each
management interface.
Add a new Administrator
and then try again.
Error 178: Invalid
password
The entered password is
invalid.
Enter a password using
valid characters and a
proper length.
Error 179: Insistent
Domain IDs must be
enabled
To complete this
command, Insistent
Domain IDs must be
enabled.
Enabled Insistent Domain
IDs.
Table 6: CLI Error Messages (Continued)
Message Description Action