FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
289CLI Reference Guide for Directors and Edge Switches
Error 209: Change
Request Aborted
The switch did not accept
the request.
Check that all the
parameters are correct,
and reenter the
command. If problems
persist, contact your
service representative.
Error 210: Busy
Processing Another
Request
A different switch in the
fabric was busy
processing another
request and could not
complete the command.
Check that all the
parameters are correct,
and reenter the
command. If problems
persist, contact your
service representative.
Error 211: Duplicate
Zone
The entered command
tried to add a zone name
that already exists in the
local zone set.
All zone names must be
unique. Delete or rename
the zone with the
duplicate name before
reentering the command;
or change the name of
the new zone, and
reenter the command.
Error 212: Duplicate
Zone Member
The entered command
tried to add a member
that already exists in the
zone.
No action required
Error 213: Number of
Zones Is Zero
The
config.zoning.activateZo
neSet command tried to
activate a zone set
contained in the work
area to the fabric;
however, the zone set is
empty.
A zone set must have at
least one zone to be a
valid zone set. Add at
least one zone to the
zone set, and then
reenter the
config.zoning.activateZo
neSet command to
activate the zone set in
the work area to the
fabric.
Table 6: CLI Error Messages (Continued)
Message Description Action