FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
290 CLI Reference Guide for Directors and Edge Switches
Error 214: A Zone
Contains Zero Members
The
config.zoning.activateZo
neSet command tried to
activate the zone set
contained in the work
area to the fabric;
however, the zone set
contains at least one zone
that is empty.
Each zone in the zone set
must contain at least one
zone member. Add zone
members so that each
zone has at least one
zone member; then
reenter the
config.zoning.activateZo
neSet command to
activate the zone set in
the work area to the
fabric.
Error 215: Zone Set Size
Exceeded
The size of the local
work-area zone set has
outgrown the size
supported by the CLI.
Reduce the size of the
zone set to meet CLI
requirements by doing
one or more of the
following:
■ reduce the number of
zones in the zone set
■ reduce the number of
members in a zone
■ reduce the length of
zone names
Error 218: Invalid Port
Number
The value specified for
the port number is
invalid.
Enter a port number
within the range
supported by the director
or edge switch. Valid
values are:
■ 0-11 for the Edge
Switch 2/12
■ 0–15 for the Edge
Switch 2/16
■ 0–23 for the Edge
Switch 2/24
■ 0–31 for the Edge
Switch 2/32
■ 0–63 for the Director
2/64
■ 0–127 and 132–143
for the Director
2/140
Table 6: CLI Error Messages (Continued)
Message Description Action