FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
291CLI Reference Guide for Directors and Edge Switches
Error 219: Invalid Port
Type
The value specified for
the port type is invalid.
A port may be configured
as an E_Port, a G_Port,
or an F_Port. Make sure
the port is configured
appropriately and
resubmit the command.
The Fx_port and Gx_port
types are also supported
on the Edge Switch 2/24.
Error 222: Invalid SNMP
Community Index
The value specified for
the SNMP community
index is invalid.
The SNMP community
index must be an integer
in the range 1–6. Enter
an integer in the range
1–6.
Error 223: Unknown
Error
The switch did not accept
the request.
Contact your service
representative.
Error 224: Invalid
Argument
The values entered for
one or more parameters
of the command are
invalid. For example, a
letter may have been
entered where an integer
is required.
Refer to “CLI Commands”
on page 39 for
information about the
command parameters.
Check that all parameters
are typed correctly, and
then resubmit the
command.
Error 225: Argument
Does Not Contain All
USASCII Characters
The CLI received one or
more non-USASCII
characters.
Refer to “CLI Commands”
on page 39 for
information about the
command parameters.
Check that all parameters
are typed correctly, and
then resubmit the
command.
Error 226: Argument Is
Too Long
One or more parameters
of the specified command
are invalid.
Refer to “CLI Commands”
on page 39 for
information about the
command parameters.
Check that all parameters
are typed correctly, and
resubmit the command.
Table 6: CLI Error Messages (Continued)
Message Description Action