FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
292 CLI Reference Guide for Directors and Edge Switches
Error 227: Invalid SNMP
Community Name
The value specified for
the SNMP community
name is invalid.
The community name
must not exceed 32
characters in length.
Duplicate community
names are allowed if the
corresponding write
authorizations match.
Specify a valid SNMP
community name, and
resubmit the command.
Error 228: Invalid Write
Authorization Argument
The writeAuthorization
parameter does not
contain a valid value.
Parameters must be typed
exactly to specification to
be recognized correctly
by the CLI. For more
information, see
“config.snmp.addCommu
nity” on page 94.
Error 229: Invalid UDP
Port Number
The
udpPortNum
parameter does not
contain a valid value.
Parameters must be typed
exactly to specification to
be recognized correctly
by the CLI. For more
information, see
“config.switch.insistDoma
inId” on page 104.
Error 230: Invalid WWN The WWN parameter
does not contain a valid
value.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
Parameters must be typed
exactly to specification to
be recognized correctly
by the CLI.
Error 231: Invalid Port
Number
The value specified for
the portNumber
parameter is invalid.
Refer to “CLI Commands”
on page 39 for
information about the
commands with the
portNumber parameter.
Specify a valid port
number value, and
resubmit the command.
Table 6: CLI Error Messages (Continued)
Message Description Action