FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

Error Messages
293CLI Reference Guide for Directors and Edge Switches
Error 232: Invalid
Domain ID
The value specified for
the domainId parameter
is invalid. For example,
the domainId parameter
of the
config.switch.pr
efDomainId
command requires an
integer in the range
1–31.
Refer to “CLI Commands”
on page 39 for
information about the
commands with the
domainId parameter.
Specify a valid domain ID
value, and resubmit the
command.
Error 233: Invalid
Member
The value specified for
the zoneName parameter
(the name of the zone
member) is invalid.
Refer to “CLI Commands”
on page 39 for
information about the
commands with the
zoneName parameter.
Specify a valid name for
the zone member, and
resubmit the command.
Error 234: Invalid
Command
The CLI cannot associate
an action with the
submitted command. The
command may be
misspelled, required
parameters may be
missing, or the request
may not be applicable to
the branch of the CLI tree
from which it was
submitted.
Refer to “CLI Commands”
on page 39 for the
correct command syntax
and spelling. Ensure that
the command is spelled
correctly and that all
required parameters are
included with the
command.
Refer to “Navigation of
the CLI Command Tree”
on page 26. Ensure that
the command has been
entered at the right place
in the CLI command tree,
and then resubmit the
command.
Table 6: CLI Error Messages (Continued)
Message Description Action