FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

config.port.name
57CLI Reference Guide for Directors and Edge Switches
Syntax
name portNumber “portName”
Purpose
This command sets the name for a port.
Parameters
This command has two required parameters:
Command Example
Root> config port name 4 “HP Tape Drive”
config.port.name
portNumber Specifies the port number. Valid values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0–23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140
portName Specifies the name for the port. The port name
must not exceed 24 characters in length.