FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
60 CLI Reference Guide for Directors and Edge Switches
Syntax
speed portNumber portSpeed
Purpose
This command sets the speed for a port.
Description
A port can be configured to operate at 1.0625 Gbps or 2.125 Gbps, or a negotiated
speed.
The port speed can be set only to 1.0625 Gbps if the switch speed is 1.0625 Gbps.
An attempt to set the port speed to 2.125 Gbps or to negotiate in a switch with a
1 Gbps switch speed results in an error message.
If the port speed is set to negotiate, the port and the device to which it is attached
negotiate the data speed setting to either 1.0625 or 2.125 Gbps.
Note: Port speed changes temporarily disrupt port data transfers.
Parameters
This command has two required parameters:
config.port.speed
portNumber Specifies the port number. Valid values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0–23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140
portSpeed Specifies the speed of the port. Valid values are
1g, 2g, and negotiate.