64 Installation Guide (AA-RSNGD-TE, July 2004)

Installing and Configuring the Director

54 Director 2/64 Installation Guide

Figure 15: AC power connections

HP System/e and Industry-Standard 19-inch Rack Installation

To install the director in a HP system/e or industry-standard 19-in rack, complete

the procedures in the following sections:

■ Install the Anti-tip Feet on an HP System/e Rack, page 54

■ Install Mounting Bracket Hardware in the Rack, page 55

■ Prepare the Front and Rear Rack Columns, page 59

■ Prepare the Switch for Installation, page 60

■ Finalize the Rack-Mounting Procedure, page 61

■ Sliding Shelf Installation—For an HAFM Appliance only, page 64

■ Recommended Cable Management, page 67

Install the Anti-tip Feet on an HP System/e Rack

Use the following procedure to mount anti-tip feet on a HP system/e rack only, as

shown in Figure 16:

1. Place the anti-tip feet (1), provided in the HP system/e and industry-standard

19-in rack-mount kits on the front and rear of the rack base.

2. Secure the anti-tip feet (1) to the base of the rack (front and rear).

3. Lower the rack feet (2) until they touch the floor.