64 Installation Guide (AA-RSNGD-TE, July 2004)

Installing and Configuring the Director

63Director 2/64 Installation Guide

d. Repeat step a through step c for the other side at the back of the switch.

e. At the front of the rack, insert the screws through the front mounting

brackets into the sheet metal nuts installed in the rail columns in step 1 of

“Prepare the Front and Rear Rack Columns” on page 59.

f. Tighten all screws.

Figure 25: Securing the switch to the rack

3. Connect the other ends of the PDU power cords to separate PDUs (if

installed), as shown in Figure 26; otherwise, connect the two standard AC

power cords.

Note: Hewlett-Packard recommends installing an optional PDU in the rack.

Hewlett-Packard ships two PDU power cords with the Director.

Figure 26: AC power connections