64 Installation Guide (AA-RSNGD-TE, July 2004)

Installing and Configuring the Director

77Director 2/64 Installation Guide

LAN-Connect the Director

Use these steps to connect the rack-mounted director to the Ethernet LAN

segment.

1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP2

card, as shown in Figure 38.

Figure 38: LAN-connect the director

2. Connect the remaining end of each Ethernet cable to the LAN as directed by

the customer’s network administrator.

Note: If an HAFM appliance is not available, use the Embedded Web Server (EWS)

interface. Attach the Ethernet LAN segment to an Internet connection.

1 Remote workstation

2 Ethernet hub or switch (customer

supplied)

3 HAFM appliance (laptop or

rack-mount)

4 Director 2/64