64 Service Manual (AA-RS2ED-TE, July 2004)

Diagnostics

156 Director 2/64 Service Manual

Is the Embedded Web Server interface operational?

YES NO

↓ Analysis for an Ethernet link, AC power distribution, or CTP2 card

failure is not described in this MAP. Go to “MAP 0000: Start MAP”

on page 46. If this is the second time at this step, contact the next level

of support. Exit MAP.

Inspect the Fibre Channel port segmentation reason at the Embedded Web Server

interface.

1. At the View panel, click the Port Properties tab. The View panel (Port

Properties tab) displays.

2. Click the port number (0 through 63) of the segmented port.

3. Inspect the Segmentation Reason field for the selected port.

Is the Segmentation Reason field blank or does it display an N/A message?

NO YES

↓ The director ISL is operational. Exit MAP.

The Segmentation Reason field displays a message. Table 20 lists segmentation

reasons and associated steps that describe fault isolation procedures.

Table 20: MAP 0700: Segmentation Reasons and Actions

Segmentation Reason Action

Incompatible operating parameters. Go to step 14

Duplicate domain IDs. Go to step 15

Incompatible zoning configurations. Go to step 16

Build fabric protocol error. Go to step 17

No principal switch. Go to step 19

No response from attached switch. Go to step 20

ELP retransmission failure timeout. Go to step 21