64 Service Manual (AA-RS2ED-TE, July 2004)

Diagnostics

161Director 2/64 Service Manual

Perform one of the following:

■ If the HAFM appliance has standalone diagnostic test programs resident on

the hard drive, perform the diagnostics. Refer to supporting documentation

shipped with the HAFM appliance for instructions.

■ If the HAFM appliance does not have standalone diagnostic test programs

resident on hard drive, go to step 10.

Did diagnostic test programs detect a problem?

NO YES

↓ Refer to the supporting documentation shipped with the HAFM

appliance for instructions to resolve the problem. Exit MAP.

Reboot the HAFM appliance.

1. Click Start > Shut Down. The Shut Down Windows dialog box displays.

2. Click Shut down on the drop-down list and then click OK to power off the

HAFM appliance.

3. Wait approximately 30 seconds and press the power ( ) button on the liquid

crystal display (LCD) panel to power on the server and perform power-on

self-tests (POSTs). During POSTs:

a. The green LCD panel illuminates.

b. The green hard disk drive (HDD) LED blinks momentarily, and processor

speed and random-access memory information display momentarily at the

LCD panel.

c. After a few seconds, the LCD panel displays a message, as shown in

Figure 8 on page 48.

d. Ignore the message. After ten seconds, the server performs the boot

sequence from the basic input/output system (BIOS). During the boot

sequence, the server performs additional POSTs and displays the

following operational information at the LCD panel:

—Host name.

— System date and time.

— LAN 1 and LAN 2 IP addresses.

— Fan 1, fan 2, fan 3, and fan 4 rotational speed.