64 Service Manual (AA-RS2ED-TE, July 2004)

FRU Removal and Replacement

228 Director 2/64 Service Manual

Factory Defaults

Table 24 lists the defaults for the passwords and IP, subnet, and gateway

addresses.

Table 24: Factory-set Defaults

Procedural Notes

Note: HAFM and Element Manager screens in this manual may not match the screens

on your server and workstation. The title bars have been removed, and the fields may

contain data that does not match the data seen on your system.

The following procedural notes are referenced as applicable. The notes do not

necessarily apply to all procedures in the chapter.

1. Before performing an FRU repair, read the removal and replacement

procedures for that FRU carefully and thoroughly to familiarize yourself with

the procedures, and to reduce the possibility of problems or customer down

time.

2. When performing procedures described in this chapter, follow all electrostatic

discharge (ESD) procedures, WARNING and CAUTION statements, and

statements listed in the preface of this manual.

3. After completing the steps of a detailed procedure that is referenced from

another procedure, return to the initial (referencing) procedure and continue to

the next step of that procedure.

4. After completing a replacement procedure, clear the event code reporting the

failure and the event code reporting the recovery from the Director 2/64 Event

Log (at the HAFM appliance), and extinguish the amber system error light-

emitting diode (LED) at the director front bezel.

Item Default

Customer password password

Maintenance password level-2

IP address 10.1.1.10

Subnet mask 255.0.0.0

Gateway address 0.0.0.0