64 Service Manual (AA-RS2ED-TE, July 2004)

319Director 2/64 Service Manual

Event Code Tables

An event is an occurrence (state change, problem detection, or problem

correction) that requires user attention or that should be reported to a system

administrator or service representative. An event usually indicates a switch

operational state transition, but may also indicate an impending state change

(threshold violation). An event may also provide information only, and not

indicate an operational state change. Events are reported as event codes.

This appendix lists all three-digit Director 2/64 event codes and provides detailed

information about each code. Event codes are listed in numerical order and in

tabular format, and are grouped as follows:

■ 000 through 199—system events

■ 200 through 299—power supply events

■ 300 through 399—fan module events

■ 400 through 499—control processor (CTP) card events

■ 500 through 599—fiber port module (UPM) card events

■ 600 through 699—serial crossbar (SBAR) assembly events

■ 800 through 899—thermal events

Events are recorded in the Director 2/64 Event Log at the HAFM appliance, in the

Event Log of the Embedded Web Server interface, at a remote workstation if

e-mail and call-home features are enabled, at a Simple Network Management

Protocol (SNMP) workstation, or at a host console if inband management is

enabled. An event may also illuminate the system error light-emitting diode

(LED) on the director front bezel.

In addition to numerical event codes, the tables in this appendix also provide:

■ Message—a brief text string that describes the event.