64 Service Manual (AA-RS2ED-TE, July 2004)

Event Code Tables

330 Director 2/64 Service Manual

Event Code: 071 (Continued)

Event Data

(Continued):

4 = Build fabric protocol error. A protocol error was detected during incorporation of

the Director 2/64 into the fabric. Disconnect the E_Port link, then reconnect the link.

If the condition persists, perform the data collection procedure and return the backup

CD to HP support personnel.

5 = No principal switch. No director or switch in the fabric can become the principal

switch. Modify the switch priority to any value other than 255.

6 = No response from attached switch (hello timeout). The Director 2/64

periodically verifies operation of attached fabric elements (directors or switches). The

director E_Port (at the operational director) times out and segments if the attached

device does not respond. Check the status of the attached director or switch. If the

condition persists, perform the data collection procedure (at the attached device)

and return the backup CD to HP support personnel.

7 = ELP retransmission failure timeout. A Director 2/64 that exhibits a hardware or

link failure attempted to join a fabric and transmitted multiple ELP frames to a fabric

element (director or switch). However, because of the problem, the director did not

receive responses to the ELP frames, and did not receive an FLOGI frame. After five

ELP transmission attempts, the director E_Port (failed director) times out and

segments. Go to “MAP 0000: Start MAP” on page 46 to perform hardware fault

isolation at the failed director.

Distribution: Director HAFM appliance Host

EWS

Event Log

System

Error LED

Event Log E-Mail Call

Home

Sense

Info

Link

Incident

✔✔