FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Embedded Web Server User Guide (AA-RTDRC-TE, July 2004)

Configuring the Product

39Embedded Web Server User Guide

b. At the Insistent Domain ID field, choose Enabled or Disabled. When

this parameter is enabled, the domain ID configured in the Preferred

Domain ID field becomes the active domain identification when the

fabric initializes. (The Insistent Domain ID is automatically enabled if the

SANtegrity Binding feature is installed.)

Note: If Enterprise Fabric Mode (an optional SANtegrity Binding feature) or Fabric

Binding is enabled, then Insistent Domain ID must be enabled.

c. At the Rerouting Delay field, choose Enabled or Disabled. When this

parameter is enabled, traffic is delayed through the fabric by the specified

error detect time out value (E_D_TOV). This delay ensures Fibre

Channel frames are delivered to their destination in order, even if a

change to the fabric topology creates a new (shorter) transmission path.

This parameter is only applicable if the product is being configured in a

multiswitch fabric.

Note: If Enterprise Fabric Mode (an optional SANtegrity Binding feature) is enabled,

then Rerouting Delay

must be enabled.

d. At the Domain RSCN field, choose Enabled or Disabled. When this

parameter is enabled, messages can be sent between end devices in a

fabric to provide additional connection information to host bus adapters

(HBA) and storage devices. Consult with your HBA and storage device

vendor to determine if enabling Domain RSCNs will cause problems with

your HBA or storage products.

Note: If Enterprise Fabric Mode (an optional SANtegrity Binding feature) is enabled,

then Domain RSCN must be enabled.

e. At the Suppress RSCN on Zone Set Activations field, choose Enabled

or Disabled. When this parameter is enabled, RSCN messages are

prohibited from being sent to ports on the switch following any change to

the fabric's active zone set. Consult with your HBA and storage device

vendor to determine if enabling this parameter will cause problems with

your HBA or storage products.