HP StorageWorks Director Torque Tool Caution (AA-RTDEC-TE, July 2004)

Printed in the U.S.A July 2004

Product names mentioned herein may be trademarks of their respective companies as reflected by an associated

footnote. The information in this document is subject to change without notice.

Read Me First

hp StorageWorks

Director Torque Tool Caution

The torque tool (P/N A6534-67011) with 5/32-inch

hexagonal adapter (P/N A6534-67012) shown at right

is required to remove and replace Director logic cards.

Caution: Use of the wrong tool may overtighten and damage the Director

logic and port cards. The torque tool supplied with the Director is designed to

tighten these cards and is set to release at a torque value of six inch-pounds.

Do not

use an Allen wrench or torque tool designed for use with another HP

product.

PAGE 1
Read Me First hp StorageWorks Director Torque Tool Caution The torque tool (P/N A6534-67011) with 5/32-inch hexagonal adapter (P/N A6534-67012) shown at right is required to remove and replace Director logic cards. Caution: Use of the wrong tool may overtighten and damage the Director logic and port cards. The torque tool supplied with the Director is designed to tighten these cards and is set to release at a torque value of six inch-pounds.
PAGE 2
Module Removal Procedure Module Removal Procedure Caution: Refer to the specific FRU removal and replacement procedures located in the appropriate Director service manual before performing a FRU repair. This reference gives additional steps that are required to reduce the possibility of problems or customer down time. To remove a card: 1. Insert the torque tool into the locking Allen screw at the bottom of the card. Turn the screw counterclockwise until the spring releases and the tool turns freely.