m-series rack mount kit installation instructions

Installation Instructions
6 m-series rack mount kit installation instructions
9. Make sure the shelf bracket is level, and align the rear of the shelf bracket with the
appropriate position on the rear rail, as shown in Figure 2.
10. Repeat steps 4 through 8 for the rear end of the shelf bracket.
11. Repeat steps 1 through 10 for the second shelf bracket.
12. Completely tighten all screws attaching shelf brackets to the rack rails. Torque the
screws to 22 in-lbs.
Attaching the Mounting Hardware to the Director 2/64
Use these steps to secure the mounting hardware to the switch.
NOTE: All mounting brackets are attached to the switch using 10/32 x 0.375-inch flathead
countersunk Phillips screws.
1. Locate the two front mounting brackets in the shipping carton.
2. Secure the front mounting brackets on either side of the switch, as shown in
Figure 3. For each front mounting bracket, use two screws.
.
.
Figure 3: Securing the front and rear mounting brackets
SHR-2321
StorageWorks SAN
64