m-series rack mount kit installation instructions

Installation Instructions
8 m-series rack mount kit installation instructions
After completing the steps outlined in the previous section, prepare to orient the
Director 2/64 in the rack as follows. The procedure requires two technicians.
CAUTION: The Director 2/64 weighs approximately 115 lbs. Do not attempt to lift or
carry the Director 2/64 with fewer than two people. Failure to observe this CAUTION
may result in injury to personnel or damage to the Director 2/64.
1. Carefully lift the switch into the rear of the cabinet. Slide the switch forward until
the edge of the front mounting brackets are approximately 1 inch from the rack’s
rails, as shown in Figure 4.
Figure 4: Aligning the switch in the rack
2. Align one front angle bracket with the cage nuts installed earlier, as shown in
Figure 5. See “Inserting Cage Nuts.”
SHR-2322