m-series rack mount kit installation instructions

Installation Instructions
9m-series rack mount kit installation instructions
NOTE: Make sure that the angle bracket is in contact with the outside surface of the
mounting bracket on the switch. The angle bracket will be between the rail and mounting
bracket.
3. Loosely attach the front angle bracket to the rack rail with the two panhead
Phillips screws provided, as shown in Figure 5.
4. Repeat steps 2 and 3 for the corresponding front angle bracket, as shown in
Figure 5.
Figure 5: Securing the front angle brackets
The two front angle brackets now touch the outside surfaces of the front mounting
plates.
5. Slide the Director 2/64 all the way into the rack to where the rear mounting
brackets meet the rack rails.
SHR-2323
StorageWorks SAN 64