Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

124 Fabric OS Command Reference
53-1001764-01
configDefault
22
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
-fid FID
Specifies the Fabric ID of the logical switch for which to reset the configuration.
This operand is valid only in Virtual Fabric mode, and the executing account must
have chassis permissions.
-all
Restores all nonpersistent configuration parameters to factory default values
(switch and chassis parameters). This command requires chassis permissions.
-switch
Resets the switch configuration only. This operand is not valid in VF mode.
EXAMPLES To restore all system configuration parameters to default values:
switch:admin> configdefault -all
Executing configdefault...Please wait
Setting the default config: FID = 128 Switch Name =stinger78
Already in Native Mode continuing with configDefault
Committing configuration ... done.
The switch has to be rebooted to allow the changes to take effect.
Do you want to reboot the system (y/n) [y]: y
SEE ALSO snmpConfig, configure, configureChassis, switchDisable, switchEnable