Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

272 Fabric OS Command Reference
53-1001764-01
fcipPathTest
22
fcipPathTest
Tests the data path of the FCIP complex.
SYNOPSIS fcippathtest
[--slot slot]
[-lb_mode mode]
[-nframes count]
fcippathtest
[--slot slot]
[-unit number]
[-path mode]
[-nframes count]
[-length data_length]
[-compress mode]
DESCRIPTION Use this command to verify the data paths in the FCIP complex. All data path modes run tests by
comparing Fibre Channel frames or data packets transmitted from and received by the network
processor due to the designated loopback.
This command is supported only on the Brocade 7800/FX8-24 and FR4-18i platforms. The command
syntax is platform-specific and not all options are valid on all platforms. To specify the loopback mode on
the Brocade FR4-18i, use the -path option. To specify the loopback mode on the Brocade 7800/FX8-24,
use the -lb_mode option. Both options are mutually exclusive.
When issued on the Brocade 7800 or FX8-24, this command causes the switch or blade to reboot.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
--slot slot
Specifies the slot number on which the diagnostic operates. The default is 0 and
operates on fixed-port-count products (Brocade 7800/FX8-24).
-unit number
Specifies the GbE port to test (Brocade FR4-18i only). By default, all GbE ports in
the specified slot are tested. Valid number values include the following:
0
GbE port 0
1
GbE port 1
2
All GbE ports
-lb_mode mode
Specifies the loopback mode for the test on the Brocade 7800/FX8-24 only. By
default, this test uses the External (SERDES) loopback (2). Valid values are as
follows:
1
Port loopback (loopback plugs)