Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

384 Fabric OS Command Reference
53-1001764-01
fruReplace
22
fruReplace
Provides an interactive interface to help replace a field replaceable unit (FRU).
SYNOPSIS frureplace fru
DESCRIPTION Use this command to replace a FRU. The command automatically performs the necessary backup and
restore operations to accommodate the replacement.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS The following operand is required:
fru
Specify the type of hardware component being replaced. WWN is the only
supported value, specifying the replacement of the WWN card.
EXAMPLES To replace the world wide name card:
switch:admin> frureplace wwn
This is the WWN card hot swap interface.
Continuing from this point will require
the whole process to be completed.
If this process is not complete due to a
power cycle, or CP failover, please follow
the recovery procedure in
Core Switch WWN Card
Replacement Procedure (for appropriate chassis).
Do you wish to continue [y/n]? y
Backing up WWN card data, please
wait about 25 seconds for further
instruction.
Please install the new FRU now.
If this session lost for any reason,
please re-enter the frureplace command and
follow the instructions to complete the
operation.
Please enter the word `continue' after the
new WWN card has been installed: continue
Restoring the information to the
replacement FRU now, please wait about
20 seconds to complete
Verifying the replacement FRU now...
WWN card hot swap is now complete.
FRU replacement completed successfully!
SEE ALSO None