Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

620 Fabric OS Command Reference
53-1001764-01
portCfg
22
5. On the Management Station, add route entries to get to the Brocade 7800 external inband
management interfaces.
linux# route add 192.168.1.0 netmask 255.255.255.0 gw 192.168.3.250
linux# route add 192.168.2.0 netmask 255.255.255.0 gw 192.168.3.250
6. Access the 7800 switches through the external inband management interfaces.
linux# telnet 192.168.1.10
To delete an inband management interface:
switch:admin> portcfg mgmtif ge0
delete 192.168.3.10 255.255.255.0
To delete a management route:
switch:admin> portcfg mgmtroute ge0 delete 192.168.3.0 255.255.255.0
192.168.2.250
To disable and re-enable an inband management interface:
switch:admin> portcfg mgmtif ge0 disable
switch:admin> portcfg mgmtif ge0 enable.
To configure a VLAN tag for an inband management port:
switch:admin> portcfg vlantag 10/xge0 add 172.16.30.40 30 0 --mgmt
Operation Succeeded
switch:admin> portshow vlantag all
Port: 10/xge0
Interface Address VlanId L2CoS Flags
Destination Address
------------------------------------------------------------------
172.16.30.80 30 0 Perm
172.16.50.80
172.16.30.40 30 0 Perm Net Mgmt
0.0.0.0
FUNCTION Commands supported only on the Brocade FR4-18i blade.
SYNOPSIS portcfg action [slot/]ge_port [if_action] arguments
DESCRIPTION Use this command to manage configuration parameters for ports and Gigabit Ethernet (GbE) ports on the
Brocade FR4-18i FC blade. The following commands are exclusive to this blade.
• portcfg arp - Add and delete address resolution protocol (ARP) entries. Flush ARP table.
• portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels.
- Delete, reset, and modify QoS mappings on an existing tunnel.
- Create or modify a tunnel with VLAN tagging and Class of Service (CoS).
- Create or modify a tunnel with Tape read/write Pipelining enabled or disabled.
- Create or modify a tunnel with Byte Streaming enabled or disabled.
• portcfg fastwrite - Configure the FC port for FC FastWrite.
• portcfg ficon - Manage FICON emulation in an FCIP tunnel.