Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

Fabric OS Command Reference 807
53-1001764-01
portShow
22
• Fast retransmits
• Out of order packets received
-credits
Displays FC data path credit data.
-ipsec
Displays IKE and IPSec policy information on IPSec-enabled tunnels. Security
policies are configured with the portCfg command.
-qosmap
Displays the mapping table for VC to FCIP QoS.
-bstr
Displays FCIP TCP Byte Stream statistics on Byte Stream-enabled tunnels
(Deprecated).
-hist
Displays the history of TCP connections.
-snapstart
Resets TCP statistics. The collection of the statistics restarts when this command
is executed. It ends when the -snapshow option is executed.
-snapshow
Displays the TCP statistics that were collected since startup or since the statistics
were reset with the -snapshow command.
mode
Displays mode of GbE port as either "FCIP" or "not configured".
ficon
Displays FICON emulation configuration parameters.
The syntax for portshow ficon is as follows:
portshow ficon [slot/] ge_port all | tunnel_Id [arg] [parm] [-clear]
The following arguments are supported with ficon:
-globals
Displays general FICON controls and statistics.
-images
Displays discovered Images (FCUB).
-emul
Displays emulated FDCBs.
-active
Displays active FDCBs.
-epcb
Displays Emulation Control Block (port specific).
-fhpb
Displays FICON Host Path Block.
-fdpb adrs
Displays FICON Device Path Block.
-fchb
Displays FICON Channel Control Block.
-fcub
Displays FICON Control Unit Control Block.
-fdcb adrs
Displays FICON Device Control Block.