HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 Command-Line Interface reference manual (June 2006)

42 3 - ENABLE-MODE COMMANDS
Interface type: ethernet
MTU: 1500
HW address: 00:E0:81:52:0E:21
RX bytes: 0
RX packets: 0
RX mcast packets: 0
RX discards: 0
RX errors: 0
RX overruns: 0
RX frame: 0
TX bytes: 0
TX packets: 0
TX discards: 0
TX errors: 0
TX overruns: 0
TX carrier: 0
TX collisions: 0
show ip
Description Displays Internet Protocol (IP) settings.
Syntax show ip {default gateway [static] |in-path route <interface> in-pathgateway
<interface> route [static]}
Parameters
Example
minna # show ip route
Destination Mask Gateway
10.0.0.0 255.255.0.0 0.0.0.0
default 0.0.0.0 10.0.0.1
minna #
show ip security
Description Displays IP Security Protocol (IPSec) settings. IPsec security support must also be
running when IP security is enabled, if both are not enabled a problem could result
with your security settings.
Syntax show ip security
Parameters None
Example
minna # show ip security
IP security enabled: yes
PFS enabled: yes
default gateway
[static]
Displays the default gateway or static default gateway.
in-path route
<interface>
Displays in-path route settings for inpath0_0, inpath1_1.
in-path-gateway
<interface>
Displays in-path gateway settings for inpath0_0, inpath1_1.
route [static] Displays the IP route or IP static route.