HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 Command-Line Interface reference manual (June 2006)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 59
4 - CONFIGURATION-MODE
C
OMMANDS
CHAPTER 4 Configuration-Mode Commands
In This Chapter This chapter is a reference for configuration-mode commands. Configuration-mode
commands set configuration properties for the HP EFS WAN Accelerator.
To execute configuration-mode commands, you must first enter enable-mode.
To enter configuration-
mode
1. Connect to the CLI. For detailed information, see “Connecting to the CLI” on
page 19.
2. To enter enable-mode, at the system prompt enter:
host> enable
3. To enter configuration-mode, at the system prompt enter:
host # configure terminal
host (config) #
You are in configuration-mode.
To exit configuration-mode, enter exit. For information about the exit command, see
“exit” on page 23.
This chapter describes the following configuration-mode commands:
 “aaa authentication login default,” next
 “aaa authorization map default-user” on page 66
 “aaa authorization map order” on page 66
 “arp” on page 67
 “banner” on page 67
 “boot system” on page 68
 “clear arp-cache” on page 68
 “cli clear-history” on page 68
 “cli default auto-logout” on page 69
 “cli default paging enable” on page 69
 “cli session” on page 69