HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 Command-Line Interface reference manual (June 2006)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 95
4 - CONFIGURATION-MODE
C
OMMANDS
in-path neighbor keepalive interval
Description Sets the time interval between keep-alive messages with the neighbor HP EFS WAN
Accelerator for connection forwarding.
Syntax in-path keepalive interval <seconds>
Parameters
Example
minna (config) # in-path neighbor keepalive interval 10
minna (config) #
in-path neighbor port
Description Sets the neighbor port for the HP EFS WAN Accelerator in connection forwarding
deployments.
Syntax in-path neighbor <port>
Parameters
Example
minna (config) # in-path neighbor port 7850
minna (config) #
in-path oop all-port enable
Description Enables virtual in-path support on all ports for failover deployments with PBR and
CDP. The no command option disables support for all ports.
Virtual in-path failover deployments require CDP on the HP EFS WAN Accelerator to
bypass the HP EFS WAN Accelerator that is down.
CDP is proprietary protocol used by Cisco routers and switches to obtain neighbor IP
addresses, model, IOS version, and so forth. The protocol runs at the Open System
Interconnection (OSI) layer 2 using the 802.3 Ethernet frame.
For detailed information about how to configure an HP EFS WAN Accelerator for PBR
with CDP, see the HP StorageWorks Enterprise File Services WAN Accelerator
Deployment Guide.
Syntax in-path oop all-port enable
Parameters None
<seconds> Specifies the number of seconds between keep-alive messages.
The default value is 10.
<port> Specifies the neighbor HP EFS WAN Accelerator port. The
default value is 7850.