HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 Release Notes (392363-004, June 2006)

12
HP System Management Homepage
When logging in to the HP System Management Homepage, use the admin login only; do not attempt to
use a Radius or TACACS+ login.
The login page of the HP System Management Homepage does not allow a blank password. Set the
admin account password before attempting to login to the HP System Management Homepage.
When sending test traps from the HP System Management Homepage (Settings - SNMP Webagent -
SNMP Configuration), only version 1 traps are sent. Set a version 1 trap destination using the general
system Management Console (Setup -> Reports -> SNMP Trap Receivers) before attempting to send a test
trap using the HP System Management Homepage.
HP Integrated Lights-Out Network Settings
Modifying settings using the Web-based interface of the HP Integrated Lights-Out (iLO) Network Settings
page (Administration -> Network Settings) can result in the system locking up. If Automatic Server Recovery
(ASR) is enabled, the system will reboot after the ASR timeout value (see the system's ROM-Based Setup
Utility (RBSU) to determine if ASR is enabled.) To avoid this, access the WAN Accelerator Command-Line
Interface (CLI) and issue the following commands prior to modifying Network Settings on iLO:
enable
configure terminal
hp agents stop
Then, modify the Network Settings on iLO. After you've finished modifying the Network Settings, start the
HP agents using the CLI:
hp agents start
An alternative is to modify the iLO settings using the iLO ROM-Based Setup Utility, available during system
boot. See the HP Integrated Lights-Out homepage at http://www.hp.com/servers/lights-out for
information about iLO and the HP ROM-Based Setup Utility User Guide on the Documentation CD for
information about RBSU.
Shutting down the system
When shutting down the system using the Web-based interface or the Command-Line Interface, the system
will not automatically power down. A few minutes after the shutdown command is issued, the system will
be in a mode that is safe to power down by using the power button.
Documentation notes
HP StorageWorks Enterprise File Services WAN Accelerator Command-Line
Interface Reference Manual
The following commands were omitted:
[no] protocol cifs opt-strict-lock enable
show protocol cifs internal
NOTE: The [no] protocol cifs opt-strict-lock enable command provides strict
optimization for the HP EFS WAN Accelerators when they do not optimize writes if the file does not have
exclusive oplock and a file is shared for read/write (for example, when PFS share mode denies both read
and write to a file).
show protocol cifs internal: displays CIFS internal settings.
[no] protocol cifs enable: enables or disables CIFS optimizations.
[no] protocol mapi enable: enables or disables MAPI optimizations.