HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 Release Notes (392363-004, June 2006)

HP StorageWorks Enterprise File Services WAN Accelerator 2.1.5 release notes 9
Run the version 2.1.5 software for a period of time to ensure stability.
NOTE: Every time a new HP EFS WAN Accelerator is upgraded to version 2.1.5, you must configure
each of the HP EFS WAN Accelerators already running version 2.1.5 to communicate with it using the
version 2.1.5 protocol.
For example, if WAN Accelerator-4 is upgraded to version 2.1.5.
1. On WAN Accelerator-1, at the system prompt, enter the following commands:
SH1 (config) # peer <WAN Accelerator-4 IP addr> version min 6
SH1 (config) # peer <WAN Accelerator-4 IP addr> version max 6
SH1 (config) # write memory
SH1 (config) # restart
2. On WAN Accelerator-2, at the system prompt, enter the following commands:
SH2 (config) # peer <WAN Accelerator-4 IP addr> version min 6
SH2 (config) # peer <WAN Accelerator-4 IP addr> version max 6
SH2 (config) # write memory
SH2 (config) # restart
3. On WAN Accelerator-3, at the system prompt, enter the following commands:
SH3 (config) # peer <WAN Accelerator-4 IP addr> version min 6
SH3 (config) # peer <WAN Accelerator-4 IP addr> version max 6
SH3 (config) # write memory
SH3 (config) # restart
4. On WAN Accelerator-4, at the system prompt, enter the following commands:
SH4 (config) # peer 0.0.0.0 version min 5
SH4 (config) # peer 0.0.0.0 version max 5
SH4 (config) # peer <WAN Accelerator-1 IP addr> version min 6
SH4 (config) # peer <WAN Accelerator-1 IP addr> version max 6
SH4 (config) # peer <WAN Accelerator-2 IP addr> version min 6
SH4 (config) # peer <WAN Accelerator-2 IP addr> version max 6
SH4 (config) # peer <WAN Accelerator-3 IP addr> version min 6
SH4 (config) # peer <WAN Accelerator-3 IP addr> version max 6
SH4 (config) # write memory
SH4 (config) # restart
NOTE: If you upgrade the remaining WAN Accelerators in your network (WAN Accelerator-5 through
WAN Accelerator-10), and there are no more version 1.2.6 WAN Accelerators, you can remove all the
version configurations on WAN Accelerator-1 through WAN Accelerator-4.
1. Connect to the Management Console on each WAN Accelerator.
2. Install the version 2.1.5 image in the Setup: Software Upgrade page.
3. Save the current configuration in the Setup: Configuration Manager page.
4. Reboot the WAN Accelerator in the Setup: Reboot WAN Accelerator page.
5. Connect to the CLI on each of the 3 WAN Accelerators you originally upgraded (that is, WAN
Accelerator-1, WAN Accelerator-2, WAN Accelerator-3, WAN Accelerator-4).
6. On WAN Accelerator-1, at the system prompt, enter the following commands:
SH1 > enable
SH1 # configure terminal