HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

102 4 - CONFIGURATION-MODE COMMANDS
in-path rule deny
Description Denies connections for the source network and destination network, when packets for
connections match the in-path rule the HP EFS WAN Accelerator actively tries to
reset the connection.
Syntax in-path rule deny {scraddr <addr> dstaddr <addr> dstport <port> rulenum
<rulenum>} [vlan <vlan tag ID>]
Parameters
Example
minna (config) # in-path rule deny scraddr 10.0.0.1 dstaddr 10.0.0.2
rulenum 4
minna (config) #
in-path rule discard
Description Packets for connections that match the rule are dropped silently. The HP EFS WAN
Accelerator filters traffic that matches the rules in discard.
Syntax in-path rule discard {scraddr <addr> dstaddr <addr> dstport <port> rulenum
<rulenum>} [vlan <vlan tag ID>]
srcaddr <addr> Specifies the source IP address.
dstaddr <addr> Specifies the destination IP address.
dstport <port> Specifies the destination port for this rule. The destination port can
be a single port (number), a port label, or all specifies all ports.
rulenum <rulenum> Specifies the rule number: 1-N, start, or end. The rule inserts itself
at the rule specified. For example, if rulenum is 3 then the new rule
will be #3, the old #3 rule will be #4 and so forth. The start option
specifies the rule to be the first rule and end specifies it to be the last
rule.
vlan <vlan tag ID> Specifies the VLAN tag ID for which the rule applies. The VLAN
identification number is a value with a range from 0-4094 (0
specifies no-tagging).