HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 135
4 - CONFIGURATION-MODE
C
OMMANDS
listen on a single pre-defined port so that access to ports can be controlled or locked
down on the firewall. The no command option disables NSPI support.
In out-of-path deployments, if you want to optimize MAPI Exchange by destination
port. You must define in-path rules that specify the following ports on the client-side
HP EFS WAN Accelerator:
 Port 135. The Microsoft end-point mapper port
 Port 7830. The HP EFS WAN Accelerator port used for Exchange traffic
 Port 7840. The HP EFS WAN Accelerator port used for Exchange Directory
NSPI traffic
If you changed the Microsoft Exchange Information Store Interface port in your
environment, in the Setup: Advanced Networking - Protocol MAPI page on the client-
side HP EFS WAN Accelerator, change port 7830 to the static port number you have
configured in your Exchange environment. The CLI commands for MAPI and NSPI
port configuration are:
protocol mapi port <port>
protocol mapi nspi port <port>
For further information, see Microsoft Exchange Information Store Interface at http:/
/support.microsoft.com/default.aspx?scid=kb;en-us;270836.
Syntax protocol mapi nspi <port>
Parameters
Example
minna (config) # protocol mapi nspi port 2125
minna (config) #
protocol mapi nspi enable
Description Enables NSPI MAPI. NSPI MAPI is enabled by default. The no protocol mapi nspi
enable command disables NSPI MAPI optimization for testing purposes.
Syntax protocol mapi nspi enable
Example
minna (config) # protocol mapi nspi enable
minna (config) #
protocol mapi port
Description Sets the incoming MAPI Exchange port. The default value is 7830. The no command
option resets the MAPI port to the default value.
Syntax protocol mapi port <port>
<port> Specifies the incoming NSPI port number. The default value is 7840.