HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

150 4 - CONFIGURATION-MODE COMMANDS
In the out-of-path deployment, you define which port to listen to on the server HP EFS
WAN Accelerator and you define an in-path fixed-target rule on the client HP EFS
WAN Accelerator to point to the service ports for the traffic you want to apply QoS to.
You cannot map the following ports.
Syntax service map-port <dest port> <service port>
Parameters
Example
minna (config) # service map-port 7018 8000
minna (config) #
service neural-framing stats enable
Description Enables neural-framing statistics. By default statistics are disabled. Neural framing
enables the HP EFS WAN Accelerator to select the optimal packet framing
boundaries for Scalable Data Referencing (SDR). SDR encoding provides the best
optimization results when the largest buffer is available before a flush is performed.
Neural framing creates a set of heuristics to intelligently determine the optimal
moment to flush TCP buffers. The HP EFS WAN Accelerator continuously evaluates
these heuristics and uses the optimal heuristic to maximize the amount of buffered data
transmitted in each flush, while minimizing the amount of idle time that the data sits
in the buffer. The no command option disables neural-framing statistics.
You must set the neural framing mode (algorithm) for your in-path rules on which you
want to apply neural framing.
Syntax service neural-framing stats enable
Parameters None
Example
minna (config) # service neural-framing stats enable
minna (config) #
Port Description
22 Reserved for Secure Shell (SSH).
80, 443, and 446 Reserved for the HP EFS WAN Accelerator Manager.
139, 445, and 977 Reserved for Proxy File Service (PFS). These ports are only
excluded if you have PFS enabled.
7800-7899 Reserved by HP (except 7800 and 7810).
8777 Reserved for CIFS transparent prepopulation;. This port is
excluded only if you have CIFS prepopulation enabled.
<dest port> Specifies the destination port you want to map.
<service port> Specifies the service port you want to map to.