HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Command-Line Interface Reference Manual (392361-004, June 2006)

152 4 - CONFIGURATION-MODE COMMANDS
snmp-server enable
Description Enables an SNMP server. The no command option disables the SNMP server or traps.
Syntax snmp-server enable [traps]
Parameters None
Example
minna (config) # snmp-server enable
minna (config) #
snmp-server host
Description Sets the SNMP server host, traps, and version. The no command option disables the
SNMP server host.
Syntax snmp-server {host <hostname or IP address>} [traps <host>] [traps version
<versionnumber>]
Example
minna (config) # snmp-server host minna
minna (config) #
snmp-server listen enable
Description Enables SNMP interface restrictions to this system. The no command option disables
SNMP interface restrictions which causes the SNMP to accept connections from all
interfaces.
After you have enabled interface restrictions, you must specify which interfaces to
accept connections on using the snmp-server listen interface command. If the list of
interfaces is empty, all interfaces are accepted. If the list of interfaces has at least one
entry, then the server only listens on that subset of interfaces.
NOTE: This option is available in the CLI only.
Syntax snmp-server listen enable
Parameters None
Example
minna (config) # snmp-server listen enable
minna (config) #
host <hostname or IP
address>
Specifies the host name or IP address for the SNMP server.
traps <host> Specifies the SNMP host on a community.
traps version
<versionnumber>
Specifies the SNMP version of traps to send to this host.